Metric Dimensioning Guide

From Draftsperson.net

Written by Allan Created 2-July-2004

Lines

  • Projection lines indicate extremities of a dimension. A gap of 1mm is generally drawn from the object to the start of the projection line. An extension of 2mm is generally drawn past the dimension line.
  • Dimension lines run between the projection lines. They generally terminate with and arrowhead or tick. Arrowheads are usually 3x1mm and ticks, 2mm long.
  • Thin linework should be used of dimension and projection lines.
  • For dimensions that cannot be drawn to there true termination point, the free end is terminated in a double arrowhead.
  • 15 x scale is the formula for working out the gap between dimension lines and the object.

Notation

  • Dimensions are usually in millimetres (millimeters). Place a note in the title block stating "ALL DIMENSIONS IN mm" to avoid the need to specify "mm" after every number.
  • Dimensions lest than 1 should lead with a "0" before the decimal point. Example: 0.5
  • Angular dimesions are specified in decimal degrees, degrees and minutes or degrees minutes and seconds. Example: 10.5° - 10°30' - 10°30'30"
  • When specifying an overall dimension, one non-critical component dimension should be omitted. Where all component dimesions must be specified, and overall lenght should be specified as an auxiliary dimension.
  • Auxiliary dimensions should be shown in brackets or noted "REFERENCE".
  • Dimensions that are not to scale are underlined or noted "NTS".
  • Where the "plus minus" symbol appears after a number, the number has been rounded of to the nearest whole number. Generally this is not required, unless in clears up why a dimension string does not close off.

Alignment

  • There are two common methods of aligning notations, "Aligned" is the most common.
  1. Aligned: The dimensions are parallel to the dimension line. Dimensions can always be readable either from the bottom or the right of the drawing.
  2. Unidirectional: All dimensions are written horizontally.

Dimensioning Rules of Thumb

Need drafting work?

We are having great success with Freelancer.com. With this website we can win all types of drafting work. People from all over the world are looking for freelancers skilled in AutoCAD, Revit, Civil 3D and Microstation, are you one of those people? If so you can live the freelancer lifestyle! and work from any location you want too. Freelancer.com, it works really well - we like it - and we believe you will too.

Looking for CAD drafters?

With modern construction, software and increased legal requirements, we often require specialized assistance with our projects. Putting skilled staff on full time is not always economically feasible for small businesses. Freelancer.com solves this problem. On this website you can engage skilled drafters. Either on fixed prices for specific tasks, or reasonably priced hourly rates for longer term contracts.

E-book: AutoCAD Block Best Practices

We draw repetitively when using AutoCAD. If we manage the drawing elements as reusable contents, it will increase our productivity significantly. Not only can we draw faster, we can add information to our blocks. Which allows us to generate useful reports. This is what Edwins e-book entitled AutoCAD Block Best Practices is all about. Yes, increase your productivity with the block!


Printed from www.draftsperson.net